How to configure Netgear Nighthawk AC1900 to use tourguard VPN

[XULACS96 0]

I've searched the knowledge base but there are no clear instruction on how to do this. I've created the config file using the OpenVPN configurator on this site.  When I attempt to change my settings in router admin to use VPN service it ask for DDNS or static IP.  I have no idea what static IP I should use and were to add it within the router configurations. I do have a dedicated IP but again not sure if I should use that or not. Any help would be greatly appreciated.  I believe the router version is R6900v2. 

[Sneakergeex 0]

On 8/11/2020 at 12:09 PM, XULACS96 said:

I've searched the knowledge base but there are no clear instruction on how to do this. I've created the config file using the OpenVPN configurator on this site.  When I attempt to change my settings in router admin to use VPN service it ask for DDNS or static IP.  I have no idea what static IP I should use and were to add it within the router configurations. I do have a dedicated IP but again not sure if I should use that or not. Any help would be greatly appreciated.  I believe the router version is R6900v2. 

Was there a solution to this? I have the R6700v3 and having the same problem of not being able to connect to Torguard.

[XULACS96 0]

Sorry Sneakergeex but I have not figured this out, but if you do I would appreciate it if you circle back share what you have found. 

[Brainbleach 5]

You can't setup a commercial VPN service on the Netgear AC1900.  The only thing you can do is make your home connection a VPN that you can connect to from when your away for home.  You need to upgrade your router if you want full VPN feature sets.